Hi Sarah thanks for the reply but I had followed all the troubleshooting elements of the guidelines. I have one esp32 webcam that works so i know my setup is correct.My real question was: were is EN pin on the esp32 webcam so I could try the capacitor fix. The esp32 in that example was not a webcam version.
Esp32 Dev Kit C Cts Rts Dtr
Hi.Where did you connect the 5V power source?Make sure that you connect your power source to the 5V pin not VCC pin.That error means that the ESP32-CAM is not in flashing mode.Make sure that your GPIO 0 is connected to GND.Read this post carefully and make sure that you follow ALL the steps.: -upload-code-esp32-cam/regards,Sara 2ff7e9595c
Comments